Unlock hauwei b970 3g router

View previous topic View next topic Go down

Unlock hauwei b970 3g router

Post by ibrakd on Thu Oct 20, 2011 7:03 pm

Unlock hauwei b970 3g router

ibrakd

Posts : 1
Join date : 2011-10-20

View user profile

Back to top Go down

Re: Unlock hauwei b970 3g router

Post by samwizegamjee on Fri Nov 02, 2012 7:28 pm

please how can i unlock my hauwei b660 router

samwizegamjee

Posts : 1
Join date : 2012-11-02

View user profile

Back to top Go down

Re: Unlock hauwei b970 3g router

Post by Prem Saini on Fri Nov 09, 2012 9:05 pm

I have 3G Huawei B970 modem locked to mobile network “VIVA” .
I'll try to explain the way that I could unlock it.
I have used the way for unlocking Huawei E220 described by Er.Dave in http://unlocke220.com/ Thanks

Basic Requirements:
1) Your Huawei B970 HSDPA modem
2) Essential Softwares: Mobile Partner, dc-unlocker client, Hex Editor, PSAS(Phone System Analisys Software) and Huawei Ccode Tool.
I have zipped all these softwares into a single file for easier download. The download: http://www.ziddu.com/download/13964884/b970unlocksoftwarfe.rar.html

For Hex Editor and Huawei Ccode Tool.exe requires no installation.Dc-unlocker client and PSAS(Phone System Analisys Software) installation is required.
Step 1:

Remove the SIM card and connect the B970 Modem with USB cable to the PC

- if your modem is recognized correctly in “Device manager” of Control Panel you should see the following detected devices
- Mass Storage USB CD rom
- 3G modem
- Com Port interface – (remember number of com port -in example is COM11)
- Bus enumerator device
check com port number of 3G modem
If some device is not recognized you must uninstall the all software for 3d modem and re-install mobile partner , and then reconnect the modem again for recognizing.
Step 2:
check the status of device –( this step can skip)
Start DC-unlocker and check the status of device


Sometimes the software does not show the correct status and needs in the modem to insert the SIM card of a mobile operator to which the modem is locked
Step 3:
Run PSAS and select : Hardware Forensics -> Use Mobile Ports

Select the correct COM interface which was detected in Device manager (COM11):
Select Command “Version Info” in “DIAG” tab and Press Send. Then you will get version number and display Successfully Send Command at Bottom of the window if you correctly set the COM interface. If this not succes then make sure you are selected correct COM interface

Now Select Read EFS (and set the End address as 00001000) and then press Lets Go. Now you will be asked to save the file. Give the name as Flash.bin and save it anywhere. You will get Successfully read EFS if everything went ok.

Step 4:
Run XVI32 Hex Editor and Open the saved file Flash.bin:
Find the String 53 64 48 in the dump. Select menu item, Search -> Find:
In the same line of the corresponding place of the right side window will show the 8 digit lock code of your modem. It is easy to find, because there is no other 8 consecutive digit in the same line of the string 53 64 48 00. Just keep searching until you find an 8 digit code grouped together (16637135).
Step 5:
Run Huawei Modem Code Tool ->Scan for hardware dongle

Your Huawei B770 HSDPA Modem should now be unlocked to any network..enjoy!
Do not forget to make hardware reset of the modem.
Step 5:
Sometimes the modem firmware also is locked as the result of my modem. After unlocking the card device worked well as a router ... but connected as a usb modem started constantly restart. So I replaced the firmware and dashboard with “South Africa Vodacom TA Version 20091120”
1. Remove SIM card from router.
2. Connect Power supply to modem
3. Connect Router to PC with network Cable .
4. Configure Your PC network card with static IP Adres
a. IP: 192.168.1.20
b. Subnet Mask: 255.255.255.0
c. Default Gateway: 192.168.1.1
5. If everything is correct you can verify that 192.168.1.1 page opens in a browser
6. Run “FmcUpdate.exe” in firmware folder . firmware file WLATCPK11007_UPDATE_ALL.BIN shouldbe there
7. Run “FmcUpdate.exe” in dashboard dashboard file Run “FmcUpdate.exe” in firmware folder . firmware file WLATCPK11007_UPDATE_ALL.BIN should be there.
8. That's all !!

avatar
Prem Saini
Admin
Admin

Posts : 34
Join date : 2011-06-27
Age : 24
Location : Meerut

View user profile http://mobilemeerut.canadaboard.net

Back to top Go down

Re: Unlock hauwei b970 3g router

Post by Sponsored content


Sponsored content


Back to top Go down

View previous topic View next topic Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum